2003 MG Zt

Front Brake disc worn, pitted or scored, but not seriously weakened corroded (1.1.14 (a) (ii))

Nearside Rear Suspension rod corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Upper Suspension rod corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Rear fog lamp not working (4.5.1 (a) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Brake disc in such a condition that it is seriously weakened all x4 (1.1.14 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Brake pipe excessively corroded both front to rears (3.6.B.2c)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Rear Rear wheel bearing has excessive play (2.6.2)

Parking brake: efficiency below requirements (3.7.B.7)

Outer Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

handbrake lever slightly high

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

All tyres worn on inner edges of tread .Within limits at time of test