2004 Mercedes-benz Vito

Anti-roll bar pin or bush worn but not resulting in excessive movement All (5.3.4 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened All (1.1.14 (a) (ii))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Chassis/subframes corroded

Coil spring corroded All (5.3.1 (b) (i))

Front Play in steering rack inner joint(s) ()

Inner and outer sills corroded

Oil leak, but not excessive (8.4.1 (a) (i))

Suspension arm pin or bush worn but not resulting in excessive movement All (5.3.4 (a) (i))

Underbody corroded

Central Inner sill crodded both sides

Front Inner Suspension rod damaged but not seriously weakened tie road both side (5.3.3 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Rear both sides arch covered in black tape

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Central Inner sill crodded both sides

Front Inner Suspension rod damaged but not seriously weakened tie road both side (5.3.3 (b) (i))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear both sides arch covered in black tape

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear outer sill covered heavily with sealant

Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

rear bumper support covered heavily with sealant

underbody and suspension components has slight surface rust

Central Rear Child Seat fitted not allowing full inspection of adult belt ()

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

full underneath of vehicle corroded

Nearside Rear Check nearside rear door latch.

Offside Obligatory mirror slightly damaged (3.3 (b) (i))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front inner sill corroded

rear exhaust rubber deteriorated

Nearside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Front coil spring broken (2.4.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front inner sill corroded

rear exhaust rubber deteriorated

Nearside Rear Nail in tyre ()

Offside Rear Nail in tyre ()

Offside Obligatory mirror missing (8.1.1)

Nearside Rear Nail in tyre ()

Offside Rear Nail in tyre ()

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Offside Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Brake pipe excessively corroded (3.6.B.2c)

Offside Front Body has a projection caused by damage (6.1.C.1)

Registration plate lamp not working (1.1.C.1d)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear coil spring incomplete (2.4.C.1a)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Headlamp aim too high (1.8)

Rear Brake lining(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)