2002 Peugeot 206

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear Axle swivel joint has slight play (2.5.A.3b)

Offside Rear Suspension arm slightly distorted (2.4.G.1)

Offside Rear wheel bearing has slight play (2.6.2)

Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Brake pedal spongy (3.3.B.1b)

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front Suspension arm locating pin locking device not properly locked (2.4.G.3b)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Rear wheel bearing has slight play (2.6.2)

Parking brake lever has little reserve travel (3.1.6b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Brake load sensing valve linkage seized (3.6.E.3)

Emissions not tested (7.0)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Service brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

sidewalls worn on offside rear tyre

Nearside Front Headlamp aim too high and too far to the left. (1.8)

Offside Outer Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

sidewalls worn on offside rear tyre

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Exhaust has a major leak of exhaust gases (7.1.2)

Registration plate lamp not working (1.1.5c)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Rear fog lamp emits a light other than red (1.3.2e)

panel damage to most panels