2005 Nissan Almera

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Registration plate inscription illegible (0.1 (b))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Power steering ram leaking Steering rack leaking (2.1.5 (a))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Sub-frame corroded but not seriously weakened Rear sub frame (5.3.3 (b) (i))

Tyre worn close to legal limit/worn on edge Both front tyres bald on edges (5.2.3 (e))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Child seat fitted not allowing full inspection of adult belt

Nail in offside front tyre

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front brake discs corroding on inside face

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)