2007 Yamaha YBR125

Drive chain sprocket carrier worn but not considered excessive bearing (6.2.1e)

Drive chain worn but not considered excessive (6.2.1e)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Rear Drive chain sprocket slightly worn (6.2.1e)

rear brake adjustment high

Headlamp aim too low (1.6)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Drive chain sprocket carrier worn but not considered excessive bearing (6.2.1e)

Drive chain worn but not considered excessive (6.2.1e)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Headlamp aim too low (1.6)

Rear Drive chain sprocket slightly worn (6.2.1e)

rear brake adjustment high

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Wheel alignment slightly misaligned. (2.5.1)

Drive chain excessively loose (6.2.1d)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear Brake locking device missing (3.2.A1e)

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Nearside Front suspension assembly slightly corroded. (2.3.1)

Offside Front suspension assembly slightly corroded. (2.3.1)

incorrect front indicator lenses fitted

Front Roller brake test indicates a binding brake (3.3.A1a)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

Rear Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear reflector on motorcycle missing (1.4.1)

Roller brake test The less effective brake control does not achieve an efficiency of 25%. (3.3.A2b)

Motorcycle structure cracked (6.1.1a) DANGEROUS

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Nearside Front suspension assembly slightly corroded. (2.3.1)

Offside Front suspension assembly slightly corroded. (2.3.1)

chainguard insecure

incorrect front indicator lenses fitted

Roller brake test Higher brake efficiency normally obtainable. (3.3.A2a)

both leavers bent bt operate ok

play in rear shock

Front Headlamp aim too high (1.6)

play in rear shock