2012 Peugeot Boxer

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Exhaust deteriorated

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Offside Side repeater not working (4.4.1 (a) (ii))

Exhaust deteriorated

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values plate limit for vehicle 1.30. actual figures on first rev was 7.67 and second figure was 10.83. (8.2.2.2 (f))

Exhaust emits excessive smoke or vapour likely to obscure the vision of other road users excessive black smoke when accelerator is depressed (8.2.2.2 (c)) DANGEROUS

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

Oil leak ()

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Registration plate lamp not working both (1.1.C.1d)

Parking brake lever has little reserve travel (3.1.6b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Front Brake pad(s) wearing thin (3.5.1g)