2004 Audi Tt

Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play dropn link (5.3.4 (a) (i))

Front Hazard warning switch inoperative (4.4.2 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play dropn link (5.3.4 (a) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

exhaust heat shield insecure

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

exhaust heat shield insecure

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Outer Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear rear brake binding (3.7.B.1)

Offside Rear rear brake binding (3.7.B.1)

Nearside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Offside Headlamp has a product on the lens but not seriously reducing light output (1.7.5a)

Nearside Front Drive shaft which forms part of the suspension coupling gaiter deteriorated, but preventing the ingress of dirt (2.4.G.4e)

eml light on

cat heat sheild insecure at rear edge at time of test.

center exhaust mount broken still supporting exhaust at time of test.

eml light on at time of test.

front and rear brake discs worn not below min thickness at time of test.

rear brakes tight not binding to x/s at time of test.

rear exhaust mount poor at time of test (corroded).

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear coil spring broken (2.4.C.1a)

cat heat sheild insecure at rear edge at time of test.

center exhaust mount broken still supporting exhaust at time of test.

eml light on at time of test.

front and rear brake discs worn not below min thickness at time of test.

rear brakes tight not binding to x/s at time of test.

rear exhaust mount poor at time of test (corroded).

cat heat sheild loose/insecure at time of test.

centert exhaust mount insecure still supporting exhaust at time of test.

n/s/r tyre slightly lumpy tread on inside edge not to x/s at time of test.

o/s/r tyre inner sidewall damaged no ply or cords exposed at time of test.

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

cat heat sheild loose/insecure at time of test.

centert exhaust mount insecure still supporting exhaust at time of test.

n/s/r tyre slightly lumpy tread on inside edge not to x/s at time of test.

o/s/r tyre inner sidewall damaged no ply or cords exposed at time of test.

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Front discs worn

Front registration plate deteriorated (6.3.1d)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front position lamp(s) not working (1.1.A.3b)