2004 Honda Jazz

Front Macpherson strut pin or bush worn but not resulting in excessive movement both side front shocker top (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material before flexi (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement wishbone arm rear bush (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material middle (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Suspension arm pin or bush excessively worn wishbone arm rear bush (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength side sill near wheel (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength near rear wheel (5.3.6 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Macpherson strut pin or bush worn but not resulting in excessive movement both side front shocker top (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material before flexi (1.1.11 (c))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement wishbone arm rear bush (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material middle (1.1.11 (c))

Front Macpherson strut corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.2.2 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Macpherson strut corroded but not seriously weakened both sides (5.3.3 (b) (i))

Rear Service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.2.2 (a) (i))

Front Registration plate inscription illegible (0.1 (b))

Central Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Brake pad(s) worn down to wear indicator (1.1.13 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Front Brake pad(s) worn down to wear indicator (1.1.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

Rear Brake pad(s) wearing thin both (3.5.1g)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both (2.2.C.1c)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Front Brake pad(s) less than 1.5 mm thick both (3.5.1g)

Nearside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

Rear Brake pad(s) wearing thin both (3.5.1g)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt both (2.2.C.1c)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)