2006 Jaguar S-type

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

n/s sill area front to rear / Repair covered in underseal

o/s sill area front to rear / Repair covered in underseal

plastic covers fitted to the n/s and o/s sill areas not allowing FULL inspection

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Fuel cap/sealing device ineffective unable to screw tight (6.1.3 (b) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced sill area front to rear (7.1.1 (a) (i))

Offside Headlamp aim too low unable to adjust / under bonnet adjuster not working (4.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

o/s sill area front to rear / Repair covered in underseal

plastic covers fitted to the n/s and o/s sill areas not allowing FULL inspection

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement lower arm inner bush (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Outer Suspension component ball joint excessively worn tie bar (5.3.4 (a) (i))

Nearside Rear Suspension component ball joint dust cover no longer prevents the ingress of dirt tie bar (5.3.4 (b) (ii))

Offside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component ball joint dust cover no longer prevents the ingress of dirt tie bar (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Shock absorbers has slight external damage to the casing corrded (5.3.2 (b))

Integral body structure is corroded but structural rigidity is not significantly reduced inner sills (6.1.1 (c) (i))

Rear subframe corrded

Nearside Rear play in traying arm

Nearside Rear play in wheel bearings

Rear both rear tyres getting low

Rear starting to rust

covers on nearside and offside outer sills

hand brake 16%

rear under body rust on suspension

Offside Rear tyre slightly perished

Front cross member corroded

Rear Brake pad(s) wearing thin (3.5.1g)

Rear cross member corroded

both front main beam lamps have moisture present

Exhaust has a minor leak of exhaust gases n/s/r rear exhaust clamp corroded (7.1.2)

n/s/r exhaust clamp corroded through

play in n/s/r track arm outer ball joint

Offside Rear Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Oil leak rear diff

Suspension arm has slight play in a ball joint (2.4.G.2)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Rear Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Oil leak rear diff

Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front position lamp(s) slightly discoloured (1.1.A.3e)

air bag light is on the dash

dsc light is on the dash

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)