1986 Mercedes-benz 420

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material both rear (1.1.11 (c))

Nearside Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Front Anti-roll bar linkage attachment bracket/mounting likely to fail (5.3.3 (b) (ii)) DANGEROUS

Nearside Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Steering box has slight free play detected at steering wheel (2.3 (a) (i))

Steering box leaking oil (2.1.1 (e) (i))

emits slight blue smoke on acceration

osr and nsr wheel arches slighy rusty

rear diff has slight oilleak

Brake pad(s) wearing thin both sides rear (1.1.13 (a) (ii))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Fluid leak, but not excessive steering box (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Steering box has slight free play detected at steering wheel (2.3 (a) (i))

Windscreen damaged but not adversely affecting driver's view stone chip/slight crack (3.2 (a) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Sound deadening material insecure under bonnet (8.1.1 (b) (i))

Engine idle speed is slightly high

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Fluid leak, but not excessive steering box (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Steering box has slight free play detected at steering wheel (2.3 (a) (i))

Windscreen damaged but not adversely affecting driver's view stone chip/slight crack (3.2 (a) (i))

Offside Rear differential seal is leaking

Oil leak ()

Windscreen has damage to an area less than a 10mm circle within zone 'A' repair carried out to existing damage (8.3.1a)

Exhaust emits excessive dense blue smoke during acceleration (7.3.A.2c)

Nearside Front Headlamp aim too high (1.8)

Offside Front Headlamp aim too low (1.8)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Engine idle speed is slightly high

Engine is misfiring

Offside Rear differential seal is leaking

Oil leak ()

Nearside Headlamp aim too low (1.8)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp aim too low (1.8)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Headlamp aim too low (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too low (1.8)

Power steering pipe(s) or hose(s) leaking (2.3.3b)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Centre Steering damper leaking oil (2.2.C.1f)

Nearside Headlamp aim too high (1.8)

Nearside front brake grabbing severely (3.7.A.2b)

Offside front brake grabbing severely (3.7.A.2b)

Front brake waring light "ON"

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)