1983 Ford Capri

Rear Passenger seat(s) missing at time of test ()

Vehicle structure is corroded but structural rigidity is not significantly reduced various points of corrosion (6.1.1 (c) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Rear Passenger seat(s) missing at time of test ()

Vehicle structure is corroded but structural rigidity is not significantly reduced various points of corrosion (6.1.1 (c) (i))

Nearside Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Wheel bearing so rough it is likely to overheat or break up (5.1.3 (b) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Fluid leaking continuously posing a serious risk to road safety petrol. tank, pipe (8.4.1 (a) (ii)) DANGEROUS

Nearside Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Indicator tell-tale inoperative (4.9.1 (a) (i))

Nearside Rear flexy brake pipe, insecure

no rear seats fitted

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Headlamp aim too high times two (4.1.2 (a))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength chassis, corroded (5.3.6 (a) (i))

Offside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Oil leaking continuously from engine posing a serious risk to road safety crank seal (8.4.1 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Indicator tell-tale inoperative (4.9.1 (a) (i))

Nearside Rear flexy brake pipe, insecure

no rear seats fitted

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Horn not working (1.6.2a)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Outer Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Outer Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear rear brake binding (3.7.B.1)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Inner Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Direction indicators not working (1.4.A.2c)

Offside Rear Registration plate lamp not working (1.1.5c)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear brake binding (3.7.B.1)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)