2008 Mercedes-benz Vito

Nearside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear wheal arch corroded

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear wheal arch corroded

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

poor repair

Nearside Front Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill hole (6.2.2 (d) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill hole (6.2.2 (d) (i))

Rear Reversing lamp inoperative (4.6.1 (a))

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear wheal arch corroded

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear wheal arch corroded

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Both Sides Inner Seal

Front Tyre worn close to legal limit/worn on edge Both Sides (5.2.3 (e))

Nearside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material Both Sides (1.1.11 (c))

Rear Inner Drive shaft joint constant velocity boot severely deteriorated Both Sides (6.1.7 (g) (i))

Both Sides Inner Seal

Front Tyre worn close to legal limit/worn on edge Both Sides (5.2.3 (e))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Brake pipe corroded, covered in grease or other material Both Sides (1.1.11 (c))

Rear Inner Drive shaft joint constant velocity boot severely deteriorated Both Sides (6.1.7 (g) (i))

GENERAL CORRODED

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced BOTH SIDE (6.1.1 (c) (i))

Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))

Nearside Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Nearside Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced prescribed areas (6.1.1 (c) (i))

all tyres wearing on edges

front discs wearing

Anti-roll bar fractured broken (2.4.G.1)

Exhaust has a major leak of exhaust gases tail pipe (7.1.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

all tyres wearing on edges

brake pad light on

front discs wearing

Parking brake lever has no reserve travel (3.1.6b)