2011 Mercedes-benz C

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Wheel bearing has slight play Both (5.1.3 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge 3mm (5.2.3 (e))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Side repeater not working (4.4.1 (a) (ii))

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Wheel bearing has slight play Both (5.1.3 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Tyre worn close to legal limit/worn on edge Both 3mm (5.2.3 (e))

Coolant appears low.

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated weeping grease. (5.3.4 (b) (i))

Nearside Front Tyre has wear to outer edge.

Nearside Rear Brake pipe corroded, covered in grease or other material Near excessive (chalked). (1.1.11 (c))

Nearside Rear Outer Brake disc worn, pitted or scored, but not seriously weakened Nearing excessive. (1.1.14 (a) (ii))

Offside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated weeping grease. (5.3.4 (b) (i))

Coolant level low

Nearside Rear Outer Brake disc worn, pitted or scored, but not seriously weakened Face corroded (1.1.14 (a) (ii))

Nearside Rear Tyre obviously under inflated (5.2.3 (l))

Offside Front Lower Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Brake pedal rubber worn

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Brake pedal rubber worn

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Nearside Front Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

both rear brake discs corroded

brake pedal rubber worn

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Nearside Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front brake lagging

all brake discs corroded

brake pedal rubber worn

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Position lamp with a multiple light source up to 1/2 not functioning (4.2.1 (a) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Offside Front brake lagging

all brake discs corroded

brake pedal rubber worn

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)