2004 Alfa Romeo GT

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill area (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Rear Exhaust system insecure mount very poor (6.1.2 (a))

Road wheel fixing missing one bolt missing on all 4 wheels (5.2.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge very low inner replace ASAP (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge very low inner advise replace ASAP (5.2.3 (e))

clutch rubber missing

coolant level low

floor pan corroded

plastic sill covers fitted

rear exhaust deteriorated

Nearside Inner Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Upper Suspension arm has slight play in a pin/bush (2.4.G.2)

surface corrosion around underbody areas

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.3.D.1)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

surface corrosion around underbody areas

surface corrosion around underbody areas

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Rear rear brake binding (3.7.B.1)

rear brake pads wearing low

surface corrosion around underbody areas