2008 Peugeot 107

Front Exhaust mounting defective (6.1.2 (a))

Nearside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill x2 (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material Both (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Brake lever has insufficient reserve travel (1.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords 155/65R14 (5.2.3 (d) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords 155/65R14 (5.2.3 (d) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Front Tyre worn close to the legal limit both (4.1.E.1)

Offside Front slight bind

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pipe slightly corroded both (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Tyre worn close to the legal limit (4.1.E.1)