2004 Ford Transit

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill/door step (7.1.1 (a) (i))

Nearside Headlamp aim not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill/door step (7.1.1 (a) (i))

Offside Headlamp aim not tested (4.1.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected front spring hanger mounting,inner sill and outer sill (5.3.6 (a) (ii)) DANGEROUS

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected rear spring hanger mounting,inner sill,cross member (5.3.6 (a) (ii)) DANGEROUS

Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected inner wheel arch (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected outer sill (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected rear spring hanger mounting,inner sill,cross member (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected front spring hanger mounting,chassis leg and inner sill (5.3.6 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material all slightly corroded (1.1.11 (c))

Offside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

all other general body and chassis corrosion,o/s/f outer sill holed just outside 30cm,advise repair

both front tyres perished

reverse lamps not working

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Headlamp aim not tested and headlamp levelling device not tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Position lamp not working (4.2.1 (a))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength chassis / crossmember (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced door step ect (7.1.1 (a) (i))

Offside Front Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Headlamp aim not tested (4.1.2 (b))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength shock mount (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength chassis and cross member (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Brake pipe slightly corroded n/s o/s to hoses (3.6.B.2c)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both lower arms rear bushes (2.4.G.2)

Offside Front inner wing holed but not in a prescribed area

Offside Front inner wing holed but not in a prescribed area

Rear Brake pipe slightly corroded axle n/s o/s (3.6.B.2c)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

n/s o/s front inner door step sills holed

Nearside Rear Suspension spring mounting prescribed area is excessively corroded outrigger area (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Suspension spring mounting prescribed area is excessively corroded midd to rear outrigger area (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded outrigger area (2.4.A.3)

Offside front brake binding (3.7.B.1)

Front Brake pipe slightly corroded n/s o/s to hoses (3.6.B.2c)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement both lower arms rear bushes (2.4.G.2)

Offside Front hub bearing not tested due to brake binding

Offside Front inner wing holed but not in a prescribed area

Offside Front inner wing holed but not in a prescribed area

Rear Brake pipe slightly corroded axle n/s o/s (3.6.B.2c)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

n/s o/s front inner door step sills holed

Nearside Outer sill holed and rusty

Offside Front brake binding slightly

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

rear chassis /spring mounts rusty both sides

Nearside Front Inner Suspension spring mounting prescribed area is excessively corroded wing (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Inner Suspension spring mounting prescribed area is excessively corroded wing (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Outer sill holed and rusty

Offside Front brake binding slightly

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

rear chassis /spring mounts rusty both sides

Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

knocking noise from o/s of steering rack

o/s/f brake binding slightly

Rear Brakes imbalanced across an axle (3.7.B.5b)

Brake pipe slightly corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

knocking noise from o/s of steering rack

o/s/f brake binding slightly

Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Inner Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Inner Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Valve stem seriously damaged (4.1.D.1e)

Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

rear brakes are slightly uneven

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear brake application uneven (3.7.B.2)

Nearside rear brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pipe slightly corroded (3.6.B.2c)

N/s/r hub bearing not checked due to brake binding.

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

Front Brake pipe slightly corroded (3.6.B.2c)

Front screen damaged n/s outside swept area.

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front screen n/s has a large crack but not in a swept area.

Viscos fan hub bearing is worn and has free play in it.also squeak in front of engine ?

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

n/s/f mirror glass damaged but can still clearly to the rear advise to replace.

Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

n/s/f mirror glass damaged but can see clearly to the rear

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

n/s door mirror glass cracked not obscured view

Fuel system component leaking (7.2.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

n/s door mirror glass cracked not obscured view

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)