2004 Honda Civic

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Brake pipe excessively corroded 2 at t piece (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Rear Exhaust has a minor leak of exhaust gases corroded requires repair (6.1.2 (a))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Suspension arm ball joint excessively worn bottom ball (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

tool required to access bonnet

Nearside Side repeater with a multiple light source more than 1/2 not functioning (4.4.1 (a) (ii))

tool required to access bonnet

tool required to access bonnet

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Brake pipe inadequately clipped or supported temp repair (1.1.11 (d) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Brake pipe likely to become detached or damaged (1.1.11 (d) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Brake pipe inadequately clipped or supported temp repair (1.1.11 (d) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords badly detoriated (5.2.3 (d) (i))

Rear Exhaust mounting defective at join (6.1.2 (a))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Inner Wing Trim Insecure

Offside Front Outer Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded Including Support (3.6.B.2c)

Rear Exhaust Box Bracket

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Brake pipe inadequately supported (3.6.B.1)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Inner Wing Trim Insecure

Offside Front Outer Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded Including Support (3.6.B.2c)

Rear Exhaust Box Bracket

Nearside Front Tyre worn close to the legal limit 2mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit 2mm (4.1.E.1)

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre worn close to the legal limit 2mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit 2mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nail in offside rear tyre

two nails on o/s/r tyre

Nail in offside rear tyre

slight cuts on o/s/r tyre on side wall

Front Brake pad(s) wearing thin (3.5.1g)

both front tyres wearing on inner edges

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

both front tyres wearing on inner edges