2012 Hyundai IX35

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Front Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Nearside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

vehicle has bonnet damage

Nearside Front Suspension arm pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Rear Suspension arm pin or bush excessively worn rear front upper arm (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Suspension arm pin or bush excessively worn rear front upper arm, (5.3.4 (a) (i))

vehicle has bonnet damage

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Upper Suspension arm pin or bush excessively worn front tie rod arm (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn also boot ripped (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn lower arm rear bush (5.3.4 (a) (i))

Offside Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Upper Suspension arm pin or bush excessively worn front tie rod arm (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement lower arm rear bush (5.3.4 (a) (i))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension arm pin or bush excessively worn trailing arm bush outer body as corroded and fell apart leaving the bush un bonded (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Brakes imbalanced across an axle 53% (1.2.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick pad squealer touching disc (1.1.13 (a) (ii)) DANGEROUS

Front Brakes imbalanced across an axle by more than 50% 58% (1.2.1 (b) (ii)) DANGEROUS

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement lower arm rear bush (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Service brake lagging in operation (1.2.1 (d))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Front Brakes imbalanced across an axle by more than 50% (1.2.1 (b) (ii)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

covers fitted not allowing full inspection

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Parking (secondary brake) on a single line braking system grabbing severely binding (1.3.1 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Road wheel fixing missing NUT (5.2.1 (a) (i))

covers fitted not allowing full inspection

Offside Rear Tyre worn close to legal limit/worn on edge bald on the inner edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear tyre is low on the inner edge of tread

engine cover and under trays fitted

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside front brake binding (3.7.B.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front tyre is just legal ... advice change

Offside Front Tyre worn close to the legal limit on 2mm and bald on the inner edge of tread (4.1.E.1)

Offside Rear tyre is low on the inner edge of tread

engine cover and under trays fitted

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

covers and trays fitted not allowing full inspection

Nearside Front Body has a projection caused by damage bumper insecure (6.1.C.1)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Service brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake lever has little reserve travel (3.1.6b)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

covers and trays fitted not allowing full inspection

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components