2012 Ford Focus

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Coil spring corroded both (5.3.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge Inner edge (5.2.3 (e))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Position lamp light intensity obviously reduced (4.2.3 (a) (i))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Front Anti-roll bar pin or bush excessively worn both (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))