2008 Land Rover Discovery

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Tyre worn close to legal limit/worn on edge both worn inner edges (5.2.3 (e))

Suspension component mounting prescribed area is corroded but not considered excessive both chassis rails (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both under sills (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge worn inner edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Suspension component mounting prescribed area is corroded but not considered excessive both chassis rails (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both under sills (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Suspension component mounting prescribed area is corroded but not considered excessive both chassis rails (5.3.6 (a) (i))

both chassis rails slightly corroded

offside rear metal brake pipe slightly corroded

Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Power steering pipe/hose has slight seepage (2.1.5 (a))

Brake pipe corroded, covered in grease or other material Front to rear (1.1.11 (c))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Power steering pipe/hose has slight seepage (2.1.5 (a))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Central Rear Brake pipe excessively corroded (1.1.11 (c))

n/s front brake hose slight twist

o/s front to rear brake pipe corroded

power steering fluid near minimum level mark

offside front tyre wearing on outer edge

Suspension arm has slight play in a pin/bush (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components