2004 Fiat Doblo

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Brake performance not tested (1.2.1 (g))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced inner sill (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced under sill (7.1.1 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced under sill (7.1.1 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

excessive use of corrosion tool may reveal further corrosion

some imbalance in rear brake operation. exhaust slightly deterioated

some rust in brake pipes and underbody, inner and outer sills etc

some rust in brake pipes.o/s front coil spring slightly displaced. some wear in spring shackle bushes

slight ex blow. rust in underbody.wear in spring shackles. headlamps tarnished.

head lens,s tarnished. front coil springs appear to be misplaced/out of line with top mounts.

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Front registration plate deteriorated (6.3.1d)

Nearside Headlamp aim too low (1.8)

Nearside Stop lamp not working (1.2.1b)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Headlamp aim too low (1.8)

Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

head lens,s tarnished. front coil springs appear to be misplaced/out of line with top mounts.

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Parking brake lever has little reserve travel (3.1.6b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

nearside rear bump stop missing

Exhaust tailpipe not capable of allowing the emission probe to be inserted (7.4.B.1)

Offside Front Coil spring not correctly located (2.4.C.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

nearside rear bump stop missing

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Play in steering rack inner joint(s)

bump stop worn o/s/r . n/s/r missing

front brake discs corroded

side light n/s/f slightly dim

Oil leak

both front brake discs worn

Nearside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Fuel system component leaking (7.2.3) DANGEROUS

Oil leak

both front brake discs worn

Front Brake pad(s) wearing thin (3.5.1g)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Offside Rear Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Oil leak

offside mirror slightly damaged

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)