2007 Alfa Romeo Brera

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Power steering ram has slight seepage from a joint (2.1.5 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Sub-frame corroded but not seriously weakened but covered by undertray (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Exhaust has a minor leak of exhaust gases at hanger (6.1.2 (a))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Power steering component has slight seepage from a component resrvoir (2.1.5 (a))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive jack points (5.3.6 (a) (i))

Stop lamp(s) non-obligatory stop lamp not working high level (4.3.1 (a) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened but covered by undertray (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Nearside Rear Exhaust has a minor leak of exhaust gases at hanger (6.1.2 (a))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Power steering component has slight seepage from a component resrvoir (2.1.5 (a))

Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive jack points (5.3.6 (a) (i))

Stop lamp(s) non-obligatory stop lamp not working high level (4.3.1 (a) (ii))

Front Sub-frame corroded but not seriously weakened covered by tray (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Inner Tyre has ply or cords exposed nearside and offside (5.2.3 (d) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened covered by tray (5.3.3 (b) (i))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Tyre slightly damaged/cracking or perishing both sides and offside rear has nail in (5.2.3 (d) (ii))

Rear Tyre worn close to legal limit/worn on edge nearside and offside (5.2.3 (e))

Front Inner Tyre worn close to legal limit/worn on edge nearside and offside (5.2.3 (e))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Stop lamp(s) non-obligatory stop lamp not working high level (4.3.1 (a) (ii))

Nearside Front coil spring broken (2.4.C.1a)

Nearside Front front brake binding (3.7.B.1)

Offside Front coil spring broken (2.4.C.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)