2007 Kia Picanto

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Coil spring corroded both side (5.3.1 (b) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Driver's door cannot be opened from inside the vehicle (6.2.3 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Upper Macpherson strut mounting damaged but not seriously weakened mount has play (5.3.3 (b) (i))

Rear Outer Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Nearside Front Headlamp insecure (4.1.1 (c))

Offside Front Upper Macpherson strut mounting damaged but not seriously weakened mount has play (5.3.3 (b) (i))

Rear Outer Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Subframe mounting repair covered in underseal (5.3.6 (a) (i))

Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp aim too high (1.8)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brake pipe slightly corroded Nearside rear, cleaned off and oiled at time of test. (3.6.B.2c)

Exhaust system not adequately supported Centre exhaust mounting broke (7.1.1)

Tyre has a bulge, caused by separation or partial failure of its structure Offside front, tread separation (4.1.D.1b)

Brake pipe slightly corroded Nearside rear, cleaned off and oiled at time of test. (3.6.B.2c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brake pad(s) wearing thin (3.5.1g)