2010 Vauxhall Insignia

Front Front suspension arms rear bushes slightly cracked

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Rear springs slightly corroded

Rear Shockers corroded but not weakened

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

exhaust heat shield loose

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Nearside Front Windscreen wiper blade defective (3.4 (b) (i))

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Exhaust has a major leak of exhaust gases Front flexi (7.1.2)

Exhaust has a minor leak of exhaust gases front flexi deteriorated (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened both (3.5.1i)

front brakes slighly binding

Offside Rear coil spring broken (2.4.C.1a)

Nail in nearside rear tyre

front brakes slighly binding

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)