2001 MG Zr

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust noisy (8.1.1 (a))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust noisy (8.1.1 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Inner Subframe mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Inner Subframe mounting prescribed area damaged but not considered excessive arch area end of inner sill (5.3.6 (a) (i))

Offside Rear Outer Subframe mounting prescribed area damaged but not considered excessive sill (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Central Rear Stop lamp not working (1.2.1b)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Outer Subframe mounting prescribed area is excessively corroded sill (2.4.A.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside rear parking (secondary) brake grabbing severely (3.7.B.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Seat belt stitching slightly frayed (5.2.2b)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Inner Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front to rear brake pipe slightly corroded

Rear exhaust shield loose

Centre section exhaust slight deterioration

Deep cracks in nearside rear tyre appearing

An item not tested (Manual)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nail in offside rear tyre

o/s/r tyre sidewall split not showing chord

Front Brake pad(s) wearing thin (3.5.1g)

front seats not tilting forward with lever cables snapped

Nearside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Offside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)