2008 Peugeot 107

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Horn not working (7.7 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Brake pipe leaking on a hydraulic braking system front to rear at front (1.1.11 (b) (ii)) DANGEROUS

Brake hydraulic reservoir fluid level below minimum level (1.1.10 (d) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Tyre worn close to legal limit/worn on edge on both sides of vehicle (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement bush (5.3.4 (a) (i))

Rear brake application uneven

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

corrosion present on floor to sills, chassis and suspension components

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sills, floor to sills and subframe mounts on both sides of vehicle (5.3.6 (a) (i))

Rear suspension components corroded

Sub-frame corroded but not seriously weakened front and rear (5.3.3 (b) (i))

Emissions not tested exhaust leak negatively affecting reading (8.2.1.2 (d))

Nearside Front Lower Suspension arm pin or bush excessively worn bush (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle beam mount around brake pipe bracket (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases joint (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor to sill, inner sill & axle beam mount (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive floor to sill, inner sill & axle beam mount (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear suspension components corroded

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement bush (5.3.4 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Sub-frame corroded but not seriously weakened front & rear (5.3.3 (b) (i))

Nearside Brake pipe excessively corroded front to rear at rear (1.1.11 (c))

Offside Brake pipe excessively corroded front to rear at rear (1.1.11 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement bush (5.3.4 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Sub-frame corroded but not seriously weakened front & rear (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Brake pipe corroded, covered in grease or other material both front to rear (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

front tyres badly worn inner edges and will soon be showing canvas 155 65 14

rear brakes operating out of balance - suggest inspected

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

front tyres badly worn inner edges and will soon be showing canvas 155 65 14

rear brakes operating out of balance - suggest inspected

o/s rear wheel bearing noise

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Inner Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Coolant leak

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

exhaust system corroded

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Rear Stop lamp not working (1.2.1b)

exhaust system hangers slightly corroded

Front registration plate deteriorated but not likely to be misread (6.3.1d)

exhaust system hangers slightly corroded