2007 Chevrolet Matiz

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Lower Seat belt anchorage prescribed area strength or continuity significantly reduced centre outer sill (7.1.1 (a) (i))

Offside Front Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Lower Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Nearside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Nearside Front Tyre worn close to the legal limit 165/65/13 2mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit tracking advised 3mm (4.1.E.1)

Central Exhaust has a major leak of exhaust gases mid box (7.1.2)

Front Exhaust system not adequately supported rubber (7.1.1)

Nearside Rear Brake pipe excessively corroded front to rear (3.6.B.2c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Brake pipe excessively corroded front to rear (3.6.B.2c)

Offside Front Front wheel bearing rough when rotated (2.5.A.2) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit 165/65/13 2mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit tracking advised 3mm (4.1.E.1)

Nearside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower engine sump has slight oil leak

Offside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Offside Rear has cracking in the tread

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear rear brake binding (3.7.B.1)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Nearside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Offside Front Lower engine sump has slight oil leak

Offside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Offside Rear has cracking in the tread

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Corrosion to O/S front to rear metal brake pipe.

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)