2002 Mercedes-benz Vito

Body has a sharp edge caused by corrosion both sills corroded through (6.1.C.1)

Exhaust system not adequately supported (7.1.1)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Front wheel bearing has excessive play (2.5.A.3c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Electrical wiring insecure sensor wiring insecure (1.9.2a)

Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Front drive shaft coupling is excessively worn (2.5.C.1c)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake lever has no reserve travel (3.1.6b)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Ball joint has excessive play (2.2.B.1f) DANGEROUS

Offside Front Ball joint has excessive play (2.2.B.1f) DANGEROUS

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Front Suspension component mounting prescribed area is corroded but not considered excessive to rears both sides inner sills (2.4.A.3)

Offside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt inner / outer (2.5.C.1a)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive to rear outer in various places (2.4.A.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Additional braking device insecure (3.6.I.1)

Brake lever has abnormal movement of levers indicating maladjustment (3.5.1f)

Nearside Rear coil spring broken (2.4.C.1a)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Front drive shaft coupling flexible rubber or fabric coupling unit severely cracked (2.5.C.1d)

Offside Headlamp aim too high (1.8)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Body has slight corrosion (6.1.B.2)

Hand brake travel slightly high.

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear suspension springs corroded.

Nearside Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Rear Exhaust system not adequately supported (7.1.1)

Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Play in steering rack inner joint(s)

Rear Vehicle structure has slight corrosion (6.1.B.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Shields missing off both rear shock absorbers.