2004 Daihatsu Hijet

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced rear crossmember (6.1.1 (c) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Lower Coil spring mounting corroded but not seriously weakened (5.3.1 (b) (i))

Rear Cross member corroded and holed, but not within any prescribed area.

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Rear Exhaust has a major leak of exhaust gases from center box to tail. (6.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected bottom of wheel arch. (5.3.6 (a) (ii)) DANGEROUS

Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected bottom of wheel arch. (5.3.6 (a) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Rear Lower Coil spring mounting corroded but not seriously weakened (5.3.1 (b) (i))

Rear Cross member corroded and holed, but not within any prescribed area.

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Offside Obligatory mirror deteriorated, but not seriously affecting the rear view (8.1.2a)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front front brake binding (3.7.B.1)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Service brake: efficiency below requirements (3.7.B.7)

Centre unable to do emission due to exhaust major leak

Offside Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Offside Rear Direction indicator damaged, but still visible from a reasonable distance (1.4.A.2e)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Upper Vehicle structure has slight damage (6.1.A.1)

Offside Rear Upper Vehicle structure has slight damage (6.1.A.1)

Offside Rear wheel bearing has slight play (2.6.2)

Centre Front Parking brake lever is impeded in its travel (3.1.6c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)