2008 Peugeot 107

Nearside Headlamp aim projected beam image is obviously incorrect bulb in wrong (4.1.2 (c))

Nearside Rear Brake pipe excessively corroded main run brake pipe before flexi (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle mounting corroded (5.3.6 (a) (i))

Offside Front Coil spring mounting corroded and seriously weakened shock (5.3.1 (b) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill corroded within axle (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength axle mounting corroded (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust manifold heavily corroded

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Exhaust has a minor leak of exhaust gases manifold (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear axle and brake backing plates heavily corroded

Rear underside heavily corroded in places

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake performance unable to be tested pipe burst (1.2.1 (g))

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material AND N/S FRONT CORRODED (1.1.11 (c))

Front Tyre worn close to the legal limit n/s and o/s on edges (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened n/s and o/s corrosion on faces (3.5.1i)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Central Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

both front tyres worn on edges.

Nearside Rear Registration plate lamp not working (1.1.C.1d)

both front tyres worn on edges.

exhaust leak from rear joint.

front brake discs and pads worn.

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Stop lamp not working (1.2.1b)

n/s rear wheel bearing rough when rotated.