2010 Kia Picanto

Nearside Rear Brake pipe corroded, covered in grease or other material By flexible brake pipe. (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Inner Suspension spring mounting prescribed area excessively damaged significantly reducing structural strength Sill. (5.3.6 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Lower Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Nail in tyre ()

Nearside Suspension component mounting prescribed area is corroded but not considered excessive Sill. (5.3.6 (a) (i))

Offside Front Lower Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive Sill. (5.3.6 (a) (i))

Parking brake performance only just met requirement (17%)

Nearside Front Lower Steering linkage ball joint ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive Sill. (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Steering linkage ball joint ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Outer Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Outer Suspension component mounting prescribed area is corroded but not considered excessive Sill. (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive Sill. (5.3.6 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive Sill. (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Central Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake discs pitted on inner face.

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake only just met requirement (16%)

Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Oil leak ()

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front wheel bearing has slight play (2.5.A.3c)