2001 Toyota Yaris

Brake lever has insufficient reserve travel (1.1.2 (a))

Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Nearside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength coil spring housing (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Child Seat fitted not allowing full inspection of adult belt ()

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake lever has abnormal movement of levers indicating excessive wear or maladjustment Parking brake (1.1.15 (f))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Exhaust has a minor leak of exhaust gases joint (6.1.2 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Inner Tyre worn close to legal limit/worn on edge treads have worn smooth (twin depth treads (5.2.3 (e))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill corroded and holed (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is inadequately repaired sill repaired with body filler (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill corroded and holed (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is inadequately repaired sill repaired with body filler (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm inner and outer treads (5.2.3 (e)) DANGEROUS

Offside Rear Inner Tyre tread depth below requirements of 1.6mm treads (5.2.3 (e)) DANGEROUS

Front Exhaust has a minor leak of exhaust gases joint (6.1.2 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Inner Tyre worn close to legal limit/worn on edge treads have worn smooth (twin depth treads (5.2.3 (e))

Nearside Front Inner Brake pipe corroded, covered in grease or other material wheel arch area (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material small pipe at back plate (1.1.11 (c))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge and outer treads (5.2.3 (e))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner and outer treads (5.2.3 (e))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive wheel arch area (5.3.6 (a) (i))

bonnet hinges very stiff

Exhaust Lambda reading after 2nd fast idle outside specified limits various leaks (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases at front weld to heat shied, also front joint and slight leak AT REAR JOINT (6.1.2 (a))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Stop lamp(s) adversely affected by the operation of another lamp remains on with side light (4.3.3 (b))

Nearside Rear Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch area to fuel filler and shock absorber mounting area (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded small pipe at back plate (1.1.11 (c))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Inner Brake pipe corroded, covered in grease or other material wheel arch area (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material small pipe at back plate (1.1.11 (c))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge and outer treads (5.2.3 (e))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner and outer treads (5.2.3 (e))

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Upper Suspension component mounting prescribed area is corroded but not considered excessive wheel arch area (5.3.6 (a) (i))

bonnet hinges very stiff

Brake pad(s) wearing thin both front (3.5.1g)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Front Exhaust system not adequately supported X 2 mountings (7.1.1)

Nearside Rear Stop lamp remains on when the brakes are released (1.2.1e)

Nearside Rear Suspension component mounting prescribed area is excessively corroded shock mounting (2.4.A.3)

Offside Front Headlamp aim too low (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Brake pad(s) wearing thin both front (3.5.1g)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Exhaust system not adequately supported (7.1.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm devoid of tread on inner shoulder (4.1.E.1)

Offside Headlamp aim too low (1.8)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Brake pipe slightly corroded pre flexible hose (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded pre/post flexible hose (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

exhaust heat shield insecure

road wheels to be removed for further brake inspection (handbrake travel )

various points of surface corrosion on underside of vehicle

Parking brake lever has little reserve travel (3.1.6b)

Front Brake pad(s) wearing thin (3.5.1g)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Offside Rear small cracks

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear coil spring corroded (2.4.C.1b)

Offside rear wheel has slight brake bind

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside rear brake binding (3.7.B.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear coil spring corroded (2.4.C.1b)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Body has slight corrosion (6.1.B.2)

Offside Body has slight corrosion (6.1.B.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Body has slight corrosion (6.1.B.2)

Offside Body has slight corrosion (6.1.B.2)

Offside Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear park brake travel quite high

Front Brake pad(s) wearing thin (3.5.1g)

long hand/brake lever travel

o/s/f and n/s/f anti-roll bar link bushes beginning to perish

o/s/r and n/s/r tyre walls beginning to perish

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)