2003 Ford Ka

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength panel (5.3.6 (a) (i))

Offside Front Inner Subframe mounting prescribed area excessively corroded significantly reducing structural strength panel (5.3.6 (a) (i))

Offside Front Inner Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength top panel (5.3.6 (a) (i))

Offside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Windscreen washer not working (3.5 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Inner Suspension spring mounting prescribed area is corroded but not considered excessive top panel (5.3.6 (a) (i))

Nearside Rear Upper strut mount movement

Offside Front top strut mount movement

Offside Rear Upper strut mount movement

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

under car sprayed with under seal

Front Suspension component mounting prescribed area is corroded but not considered excessive both front chassis legs have corrosion all over (5.3.6 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive both front floors have corrosion near strengthening plates (5.3.6 (a) (i))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength rear chassis leg near axle mount corroded (5.3.6 (a) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Suspension component pin or bush excessively worn both rear axle mounting bushes badly deteriorated (5.3.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Suspension component mounting prescribed area is corroded but not considered excessive both front chassis legs have corrosion all over (5.3.6 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive both front floors have corrosion near strengthening plates (5.3.6 (a) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Parking (secondary brake) grabbing slightly (1.3.1 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Parking (secondary brake) grabbing slightly (1.3.1 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Subframe mount (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Subframe mount (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp insecure (4.1.1 (c))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Subframe mount (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Subframe mount (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front coil spring corroded (2.4.C.1b)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front front brake juddering slightly (3.7.A.2b)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front front brake juddering slightly (3.7.A.2b)

Emissions not tested (7.0)

Offside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front front brake juddering slightly (3.7.A.2b)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front front brake juddering slightly (3.7.A.2b)

both rear tyres are slightly perished

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

nearside front tyre outer wall damaged

nearside front wheel bearing slightly noisey

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)