2003 Lexus IS200

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords inner side wall (5.2.3 (d) (i))

Nearside Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Outer Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Rear Floor excessively deteriorated boot floor (6.2.4 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure outer side wall (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

all underbody heavily corroded

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting outer sill (6.2.2 (d) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear tyre wearing inner edge

Offside Rear Outer Body has slight corrosion sill heavily blistered but not perforated (6.1.B.2)

Nearside Front coil spring broken (2.4.C.1a)

Nearside Rear Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill holed (6.1.B.2)

Offside Front coil spring broken (2.4.C.1a)

Offside Rear Outer Body has slight corrosion sill heavily blistered but not perforated (6.1.B.2)

Windscreen washer provides insufficient washer liquid Both (8.2.3)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Nearside Headlamp aim too low (1.8)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Headlamp aim too low (1.8)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Nearside Front coil spring broken (2.4.C.1a)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Front Lower Ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front coil spring broken (2.4.C.1a)

Offside Rear coil spring broken (2.4.C.1a)

Under-trays fitted obscuring some underside components

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

rear brakes disc's corroded

rear brake disc's worn

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear brake disc excessively pitted (3.5.1h)

due to suspected lack of use light surface corrosion to front and rear brake disc inner faces