2008 Toyota Aygo

Front Suspension arm pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced side sills (6.1.1 (c) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced wheel arch (6.1.1 (c) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Obligatory mirror slightly damaged (3.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Registration plate inscription illegible (0.1 (b))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

front brake discs has surface rust

near side rearmost outer sill becoming corroded and weakened

Horn not working (7.7 (a) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim too low (4.1.2 (a))

front brake discs has surface rust

near side rearmost outer sill becoming corroded and weakened

n/side rear wheel bearing becoming noisey

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Non obligatory mirror damaged ()

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Surface corrosion in inner sills/floors, boot floor and rear chassis sections.

Suspension components have heavy surface corrosion.

Nearside Rear Service brake excessively binding WHEEL BEARING TO BE CHECKED AT RE-TEST, UNABLE TO ROTATE WHEEL (1.2.1 (f))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Non obligatory mirror damaged ()

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Surface corrosion in inner sills/floors, boot floor and rear chassis sections.

Suspension components have heavy surface corrosion.

Offside Rear tyre worn on edges

Nearside Front Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside rear brake binding (3.7.B.1)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

rear brake application uneven (3.7.B.2)

Front Brake pad(s) wearing thin (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Headlamp aim too high (1.8)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Headlamp not working on dipped beam (1.7.5a)