2008 Toyota Aygo

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

vehicle has surface rust under body

Front Wheel bearing rough when rotated both (5.1.3 (b) (i))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Rear Outer Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting both sills (6.2.2 (d) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

vehicle has surface rust under body

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

general corrosion at prescribed area+suspension components

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

general corrosion at prescribed area+suspension components

Nearside Rear Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Rear Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Rear Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Tyre tread depth below requirements of 1.6mm both rear (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Front brake disc modified but not seriously weakened (3.5.1n)

all four tyres are getting low and are cracking