2008 Yamaha Yzf R125

Central Lower Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Exhaust noisy (8.1.1 (a))

Central Wheel alignment slightly misaligned (2.4 (a))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Rear Lower Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Suspension corroded but not seriously weakened fork stantions pitted (5.3.3 (b) (i))

Front farings loose

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Steering headbearing has slight free play (2.2.2 (f) (i))

Headlamp aim unable to be tested (4.1.2 (b))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Rear Brake effort inadequate at a wheel (1.2.1 (a) (i))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Front Suspension corroded but not seriously weakened fork stantions pitted (5.3.3 (b) (i))

Front farings loose

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Brake binding but not excessively (1.2.1 (f))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Steering headbearing has slight free play (2.2.2 (f) (i))

Drive chain slightly loose (6.1.7 (c) (i))

Front suspension damping poor

Rear Shock absorber has a light misting of oil (5.3.2 (b))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Front FRONT FORKS RESTRCTED TRAVEL

Front FRONT FORKS RESTRCTED TRAVEL

Rear reflector missing (4.8.2 (a) (ii))

Steering headbearing in such a condition that steering control is adversely affected (2.2.2 (f) (ii))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Front shock absorber has light misting of stanchion both sides (2.3.3)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Drive chain slightly loose (6.2.1d)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)