2002 Fiat Seicento

Exhaust has a minor leak of exhaust gases (7.1.2)

both rear shock absorbers corroded

n/s/r tyre cracked in tread

o/s/f coil spring and shock absorber corroded

vibration through dashboard when engine rev'd

Battery insecure (1.9.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brakes imbalanced across an axle (3.7.B.5b)

Front Mechanical brake component has restricted free movement both(wheel bearings not tested) (3.5.1k)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front position lamp(s) insecure (1.1.A.3a)

Nearside Headlamp insecure (1.7.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Registration plate lamp not fitted (1.1.C.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

both rear shock absorbers corroded

n/s/r tyre cracked in tread

o/s/f coil spring and shock absorber corroded

vibration through dashboard when engine rev'd

N/S rear brake noisey when rotated

Nearside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Front Suspension component mounting prescribed area is excessively corroded FLOOR (2.4.A.3)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

N/S rear brake noisey when rotated

Nearside Headlamp not working on dipped beam (1.7.5a)

front brakes binding slightly

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

underside of vehicle corroded

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Front coil spring worn (2.4.C.1b)

Shock absorber has slight corrosion to the casing (2.7.2a)

Steering system slightly tight (2.2.D.1)

Suspension arm corroded but not seriously weakened (2.4.G.1)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

coil spring corroded (2.4.C.1b)

handbrake tight

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front coil spring worn (2.4.C.1b)

Shock absorber has slight corrosion to the casing (2.7.2a)

Steering system slightly tight (2.2.D.1)

Suspension arm corroded but not seriously weakened (2.4.G.1)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

coil spring corroded (2.4.C.1b)

handbrake tight

Shock absorber has slight corrosion to the casing (2.7.2a)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

all underside corroded

coil spring corroded (2.4.C.1b)

sill cover fitted

suspension arms corroded

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Shock absorber has slight corrosion to the casing (2.7.2a)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

all underside corroded

coil spring corroded (2.4.C.1b)

sill cover fitted

suspension arms corroded

Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Rear coil spring corroded (2.4.C.1b)

Shock absorber has slight corrosion to the casing (2.7.2a)

Suspension joint offside lower dust cover split/missing

corroded underside

Brakes imbalanced across an axle (3.7.B.5b)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Brake lever has restricted free movement (3.5.1k)

Offside rear brake binding (3.7.B.1)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Registration plate lamp not working (1.1.C.1d)

front brake application uneven (3.7.B.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Rear coil spring corroded (2.4.C.1b)

Shock absorber has slight corrosion to the casing (2.7.2a)

Suspension joint offside lower dust cover split/missing

corroded underside

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear coil spring corroded (2.4.C.1b)

Suspension joint offside lower dust cover split/missing

o/s handbrake linkage slightly siezed

Steering system slightly tight (2.2.D.1)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Steering system slightly tight (2.2.D.1)

Nearside Rear Brake pivot has restricted free movement (3.5.1k)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Parking brake lever has no reserve travel (3.1.6b)

Steering system excessively tight (2.2.D.1)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside rear brake binding (3.7.B.1)