2002 Mazda MX-5

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced leg (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases front joint missing nut (6.1.2 (a))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced leg (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases front pipe to manifold joint (6.1.2 (a))

surface corrosion o/s inner sill and floor panels

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

near side and off side sill ends corroded

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is excessively corroded outer sill corroded holed (2.4.A.3)

Sub-frame locating pin retaining device missing both rear pins missing (2.4.G.3b)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Headlamp aim too low (1.8)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Rear reflector missing (1.5.1a)

Offside Rear Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

gearbox oil leak on prop seal

surface corrosion on n/s/r outer sill panel

Nearside Rear position lamp(s) incorrect colour (1.1.A.3e)

Nearside Stop lamp not working (1.2.1b)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

gearbox oil leak on prop seal

surface corrosion on n/s/r outer sill panel

Nearside Front position lamp(s) not working (1.1.A.3b)

surface corrosion on o/s/r outer sill

surface corrosion on o/s/r outer sill

Front position lamp(s) not working (1.1.A.3b)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)