2002 Mazda MX-5

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Centre anti roll bar bush clamp fixing stud broken but still adequately supported

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive Sill riser (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Oil leak, but not excessive Engine oil (8.4.1 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Offside Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security sill (6.2.2 (d) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Brake fluid warning lamp illuminated (1.1.10 (f))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front slight draging but not showing on rbt

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear coil spring broken (2.4.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

both rear sills corroded

underside of car rusty

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

underside of car rusty

underside of car rusty

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Brake pipe slightly corroded (3.6.B.2c)

Brake pipe excessively corroded (3.6.B.2c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Parking brake lever has little reserve travel (3.1.6b)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Front Brake pad(s) wearing thin (3.5.1g)