2002 Peugeot 206

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Wheel bolt(s) missing (4.2.A.1e)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Headlamp aim too high (1.8)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Alternator belt has cracked

Coolant leak

NSR seat has child seat fitted, seat belt not tested

Nearside Front Road wheel slightly damaged (4.2.A.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Oil level low

Rear registration plate is deteriating but readable

Service is due

Nearside Headlamp aim too low (1.8)

Child seat fitted not allowing full inspection of adult belt

Driver's door mirror cracked,not affecting view. It has also been repaired

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Nearside Front Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Headlamp not working on dipped beam (1.7.5a)