2008 Toyota Prius

Brake pipe corroded, covered in grease or other material front and rear (1.1.11 (c))

Coil spring corroded front and rear all (5.3.1 (b) (i))

Front Headlamp has a product on the lens but not seriously reducing light output poor beam (4.1.4 (b))

Rear Fuel Pipe/s corroded ()

Suspension component mounting repair covered in underseal front and rear all (5.3.6 (a) (i))

heavy underseal applied

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch x2 (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Steering locking device missing track rod end locking pin missing (2.1.3 (d))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch x2 (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Coil spring corroded all (5.3.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Vehicle structure is deformed but structural rigidity is not significantly reduced (6.1.1 (a) (i))

both side headlamps have poor beam

both side sills and inner wheel arches corroded

exhaust has slight leak

under vehicle suspension components and suspension mounting areas corroded

Nearside Front Jacking point bent.

Nearside Rear Jacking Point bent.

Vehicle is starting to corrode underneath.

Offside Front Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner Sill. (6.2.2 (d) (i))

Offside Rear Inner Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Inner Sill. (6.2.2 (d) (i))

Nearside Front Jacking point bent.

Nearside Rear Jacking Point bent.

Vehicle is starting to corrode underneath.

Front Shock absorbers has light misting of oil both sides (5.3.2 (b))

underbody general corrosion

Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Rear rear exhaust heat cover in poor condition

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Brake hose excessively damaged (1.1.12 (b) (ii))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both side (1.1.14 (a) (ii))

Rear rear exhaust heat cover in poor condition

Rear registration plate incorrect (6.3.1a)

Registration plate lamp not working (1.1.C.1d)

Rear nearside and offside tyre worn low

engine covers and under trays fitted

Oil leak ()

Rear Brake pad(s) wearing thin (3.5.1g)

Under-trays fitted obscuring some underside components

cut in tread of o/s/r tyre

nail in o/s/r tyre

front brake discs corroded.

nearside rear tyre wearing on outer edge.