2004 Proton Jumbuck

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner wing area (5.3.6 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner wing area (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material rear pipes going to load sensor valve (1.1.11 (c))

Fluid leak, but not excessive power steering pipe at front bumper area (8.4.1 (a) (i))

Rear Exhaust has a minor leak of exhaust gases system corroded (6.1.2 (a))

Suspension component mounting prescribed area is corroded but not considered excessive both rear floor areas (5.3.6 (a) (i))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Outer Seat belt anchorage prescribed area is corroded but not considered excessive Sill (5.2.6)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too low (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too high (1.8)