2006 Fiat Stilo

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust system insecure (6.1.2 (a))

Nearside Front Anti-roll bar ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced under side (6.1.1 (c) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust silencer insecure (8.1.1 (b) (i))

Offside Front Anti-roll bar ball joint likely to become detached broken (5.3.4 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Undertray not fully secure (8.1.1 (b) (i))

Offside Front Suspension component ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Integral body structure is deformed but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Rear discs in poor condition

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

o/s/r tyre wearing on inside edge

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

o/s/r tyre wearing on inside edge

Nearside Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Shock absorber has slight corrosion to the casing (2.7.2a)

exhaust system corroded

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Shock absorber has slight corrosion to the casing (2.7.2a)

exhaust system corroded

offside rear brake disc overheated

front brake discs worn and very corroded on inner surface

Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Brake master cylinder fluid close to minimum level (3.6.G.1e)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)