2009 Toyota Auris

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Suspension arm corroded but not seriously weakened nearside and offside (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive nearside and offside (5.3.6 (a) (i))

Front Headlamp aim too low both sides (4.1.2 (a))

Front Registration plate inscription illegible broken (0.1 (b))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Suspension arm corroded but not seriously weakened nearside and offside (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive nearside and offside (5.3.6 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Brake disc worn, pitted or scored, but not seriously weakened front and rear (1.1.14 (a) (ii))

Front Tyre worn close to the legal limit n/s and o/s (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

advise rear exhaust heat shield loose

Nearside Rear rear brake binding (3.7.B.1)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

nearside rear brake binding

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Rear Brake pad(s) wearing thin (3.5.1g)