2009 Fiat Panda

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Exhaust system insecure (6.1.2 (a))

Nearside Front Lower Suspension arm pin or bush excessively worn Rear bush (5.3.4 (a) (i))

Engine misfiring

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge Advise renewal soon (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge Advise renewal soon (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Upper Macpherson strut pin or bush excessively worn Mounting (5.3.4 (a) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Upper Macpherson strut pin or bush worn but not resulting in excessive movement Mounting (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Tyre worn close to legal limit/worn on edge All four advise renewal now (5.2.3 (e))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake a little sluggish in operation

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear (5.3.4 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Rear Shock absorbers has an excessively worn bush (5.3.2 (c))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Brake a little sluggish in operation

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Rear (5.3.4 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively both sides (3.4 (b) (ii))

exhaust back box very corroded but not yet blowing

n/s and o/s rear axel corroded

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both front tyres worn on the inner edges

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

offside front brake binding slightly

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear coil spring corroded (2.4.C.1b)