2001 Peugeot 206

Brake load sensing valve stiff (1.1.17 (c) (i))

Brake pipe corroded, covered in grease or other material x3 and o/s/f (1.1.11 (c))

Exhaust has a minor leak of exhaust gases and deteriorated (6.1.2 (a))

Front Anti-roll bar linkage ball joint has slight play x2 (5.3.4 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement n/s and o/s (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive n/s and o/s outer sills soft (5.3.6 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (i))

Brake pipe corroded, covered in grease or other material x3 and o/s/f (1.1.11 (c))

Exhaust has a minor leak of exhaust gases and deteriorated (6.1.2 (a))

Front Anti-roll bar linkage ball joint has slight play x2 (5.3.4 (a) (i))

Front Position lamp not working x2 (4.2.1 (a) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement n/s and o/s (5.3.4 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive n/s and o/s outer sills soft (5.3.6 (a) (i))

Both Rear Brake Pipes have slight corrosion

Exhaust has minor leak of gases

Front Flexi Exhaust worn, been repaired

Rear Compensator Stiff

Sills to the rear going soft, corrosion but not excessive

Brake pipe slightly corroded 2 front to rear (3.6.B.2c)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Brake pipe slightly corroded 2 front to rear (3.6.B.2c)

Brake pipe slightly corroded 2 centre rear (3.6.B.2c)

Brake pipe slightly corroded 2 front to rear (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Brake pipe slightly corroded 2 centre rear (3.6.B.2c)

Brake pipe slightly corroded 2 front to rear (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

back box bracket snapped but system still supported

Brake valve leaking (3.6.A.1)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

back box bracket snapped but system still supported

oil level only just reading on dipstick.

Offside front tyre 2.0mm