2005 Peugeot 206

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

under carriage surface rust

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre obviously under inflated (5.2.3 (l))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Brake pedal has insufficient reserve travel (1.1.2 (a))

Offside Rear Brake drum contaminated (1.1.14 (b))

Offside Rear Hydraulic brake cylinder leaking hydraulic fluid (1.1.16 (b) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Front Brakes imbalanced across an axle by more than 50% Axle 1 (1.2.1 (b) (ii)) DANGEROUS

Nearside Front Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Brake master cylinder below minimum mark (1.1.10 (d) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Nearside Front Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Nearside rear brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front position lamp(s) not working (1.1.A.3b)

Rear Exhaust system not adequately supported (7.1.1)

Items removed from driver's view prior to test

Rear exhaust box corroded

Offside Rear Registration plate lamp not working (1.1.C.1d)

Rear exhaust box corroded

Headlamp aim too high (1.8)

Nearside Rear Wheel nut(s) loose (4.2.A.1e)

Registration plate lamp not working (1.1.C.1d)