2006 Toyota Aygo

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced both inner and outer sills (6.1.1 (c) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Headlamp lens slightly defective both (4.1.1 (b) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced both inner and outer sills (6.1.1 (c) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both (5.3.6 (a) (i))

Front Headlamp has a product on the lens so that the light output is severely reduced both side (4.1.4 (b))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Brake cable insecure (1.1.15 (c))

General underbody corrosion

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn both sides (5.1.2 (b) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Nearside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Outer Subframe mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Anti-roll bar pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Outer Subframe mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Front Exhaust mounting defective (6.1.2 (a))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Tyre worn close to legal limit/worn on edge close to 2mm (5.2.3 (e))

Offside Front Valve stem slightly misaligned (5.2.3 (j))

Rear Brake pipe corroded, covered in grease or other material Corroded (1.1.11 (c))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Tyre worn close to legal limit/worn on edge close to 2mm (5.2.3 (e))

Offside Front Valve stem slightly misaligned (5.2.3 (j))

Rear Brake pipe corroded, covered in grease or other material Corroded (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

NEARSIDE REAR BRAKE PIPE CORRODING

Offside Rear Tyre worn close to the legal limit VERY CLOSE ON INNER EDGE (4.1.E.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear tyre worn on inside

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear tyre worn on inside

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Direction indicator excessively damaged so that it is not visible from a reasonable distance (1.4.A.2e)

Offside Front Valve stem seriously misaligned (4.1.D.1e)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Registration plate lamp not working (1.1.C.1d)

n/s front tyre tread low.

n/s rear tyre tread low.

o/s front tyre wearing on edges.

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Road wheel bead rim badly distorted (4.2.A.1a)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside front brake grabbing slightly (3.7.A.2b)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)