2006 Toyota Aygo

Central Front exhaust support arm corroded off the pipe

Rear Brake hose has slight corrosion to ferrule n/s/r and o/s/r (1.1.12 (f) (i))

Rear Brake pipe corroded, covered in grease or other material n/s/r and o/s/r slightly corroded at ends (1.1.11 (c))

Rear Coil spring corroded n/s/r and o/s/r (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive n/s/r and o/s/r inner sill areas (5.3.6 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Central Front exhaust support arm corroded off the pipe

Rear Brake hose has slight corrosion to ferrule n/s/r and o/s/r (1.1.12 (f) (i))

Rear Brake pipe corroded, covered in grease or other material n/s/r and o/s/r slightly corroded at ends (1.1.11 (c))

Rear Coil spring corroded n/s/r and o/s/r (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive n/s/r and o/s/r inner sill areas (5.3.6 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Central Front Exhaust mounting defective support arm corroded off (6.1.2 (a))

Exhaust emits blue smoke during acceleration (8.2.1.2 (g))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement n/s/f and o/s/f slightly worn/cracking (5.3.4 (a) (i))

Front Headlamp light source and lamp not compatible n/s/f and o/s/f led bulbs fitted to a halogen lamp , (4.1.4 (c))

Front Suspension arm ball joint dust cover severely deteriorated n/s/f and o/s/f perishing/deteriorated (5.3.4 (b) (i))

Nearside Front Oil leak, but not excessive driveshaft seal area (8.4.1 (a) (i))

Offside Front Oil leak, but not excessive misting of oil to lower engine area (8.4.1 (a) (i))

Rear Brake hose has slight corrosion to ferrule n/s/r and o/s/r (1.1.12 (f) (i))

Rear Brake pipe corroded, covered in grease or other material n/s/r and o/s/r slightly corroded at ends (1.1.11 (c))

Rear Coil spring corroded n/s/r and o/s/r (5.3.1 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced surface corrosion visible to n/s/r and o/s/r inner sill areas (6.1.1 (c) (i))

Central Front Exhaust mounting defective support arm corroded off the pipe (6.1.2 (a))

Exhaust has a minor leak of exhaust gases slight leak at manifold and rear joint (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both slightly deteriorating/cracking (5.3.4 (a) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement n/s/f and o/s/f (5.3.4 (a) (i))

Rear Brake hose has slight corrosion to ferrule n/s/r and o/s/r (1.1.12 (f) (i))

Rear Brake pipe corroded, covered in grease or other material n/s/r and o/s/r rear ends slightly corroded/greased (1.1.11 (c))

Rear Coil spring corroded both rear springs corroded (5.3.1 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced surface corrosion visible to n/s/r and o/s/r inner sill areas (6.1.1 (c) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement n/s/r and o/s/r worn/cracking slightly (5.3.4 (a) (i))

Rear Registration plate inscription illegible deteriorated into lettering (0.1 (b))

Central Front Exhaust mounting defective support arm corroded off the pipe (6.1.2 (a))

Exhaust has a minor leak of exhaust gases slight leak at manifold and rear joint (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both slightly deteriorating/cracking (5.3.4 (a) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement n/s/f and o/s/f (5.3.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Window in an unacceptable condition bonding failed / insecure (3.2 (c) (i))

Rear Brake hose has slight corrosion to ferrule n/s/r and o/s/r (1.1.12 (f) (i))

Rear Brake pipe corroded, covered in grease or other material n/s/r and o/s/r rear ends slightly corroded/greased (1.1.11 (c))

Rear Coil spring corroded both rear springs corroded (5.3.1 (b) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced surface corrosion visible to n/s/r and o/s/r inner sill areas (6.1.1 (c) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement n/s/r and o/s/r worn/cracking slightly (5.3.4 (a) (i))

Central Front Exhaust has a minor leak of exhaust gases manifold (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both bushes slightly cracking (5.3.4 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement n/s/f and o/s/f (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake hose has slight corrosion to ferrule n/s/r and o/s/r (1.1.12 (f) (i))

Rear Brake pipe corroded, covered in grease or other material n/s/r and o/s/r at ends , greased (1.1.11 (c))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both rear trailing arm bushes worn/cracking slightly (5.3.4 (a) (i))

Tyre slightly damaged/cracking or perishing n/s/f, o/s/f and o/s/r tyres perishing/cracking (5.2.3 (d) (ii))

Exhaust has a minor leak of exhaust gases Manifold. (6.1.2 (a))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement Both. (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 1.9mm (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Both rear brake ferrules slight corrosion.

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Suspension arm pin or bush worn but not resulting in excessive movement Both rear trailing arm bushes. (5.3.4 (a) (i))

corrosion to underside but not excessive at time of test (front and rear).

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Exhaust has a minor leak of exhaust gases Manifold. (6.1.2 (a))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement Both. (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge 1.9mm (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Both rear brake ferrules slight corrosion.

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Suspension arm pin or bush worn but not resulting in excessive movement Both rear trailing arm bushes. (5.3.4 (a) (i))

corrosion to underside but not excessive at time of test (front and rear).

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Rear Slight bind on road wheel / brake - Requires further investigation

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside Rear Tyre worn close to the legal limit On 1.6mm - Age cracks - Edges worn / bald (4.1.E.1)

Offside Rear Slight bind on road wheel / brake - Requires further investigation

Offside Rear Tyre worn close to the legal limit On 1.6mm - Age cracks - Edges worn / bald (4.1.E.1)

drivers floor section requires protection on seams

front inner brake pads low

Offside Parking brake is not capable of being maintained in operation by direct mechanical action only (3.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

drivers floor section requires protection on seams

front inner brake pads low

Offside Front Seat belt insecurely fixed to the seat (5.2.1a)

n/s rear tyre on limits on outer edge and going out of shape